XXcontrollerV1.1 I've spent a bit of time looking at the code manuLRK posted earlier in the thread [[https://www.rcgroups.com/forums/showpost.php?p=16831624&postcount=318|(here)]] regarding improved ESC PWM rates (>450Hz) and, after a day or so fiddling, I have incorporated this into XXcontroller code. Theoretical maximum ESC rate is 497Hz, but probably less, as there are a few tens of micro-seconds's lost along the way.\\ Actually, I have noticed that the internal Xtal isn't very accurate, so results may vary a surprising amount. Since this is a significant change, release is now V1.1 Things to note There are 2 pairs of defines, ESC_RATE and PWM_LOW_PULSE_INTERVAL which allow you to set PWM rate. One pair you set ESC_RATE and it calculates PWM_LOW_PULSE_INTERVAL, the other pair vice-versa. PWM_LOW_PULSE_INTERVAL is measured in 10's of microSeconds (minimum 1) Stick-arming is now standard feature new define for Stick-arm side (for those non-standard folks out there ) When the controller is not armed, no signal is sent to ESC's, so they will bleep. I actually quite like this (others may not) as led isn't always easy to see. Some ESC's are a bit fussy, and you may need to re-arm to get them to sync/start correctly. Sensor calibration now takes place @ arming. also, gyro gain pots are read @ arming, so if you change them, you must re-arm for the changes to be used As a general note, the code (V1.1) is time critical.\\ Essentially, the program expects certain sections of the code to take a short period of time. What this means is that if you modify the code, you must avoid putting any long delay(s) (>200uS - yes, thats long!) in the code which gets executed when armed.\\ Failure to follow this guidline will cause motors to mis-behave. I have flown @ 450Hz with my big Quad (config) and am suitably impressed.\\ I havn't checked the results on TRI copter tho'\\ I also havn't put this on my test-bench to check PWM consistency. and finally, thanks to manuLRK ! Thats all folks - enjoy (с) https://www.rcgroups.com/forums/showpost.php?p=16982107&postcount=431 ----